Advertisement
MODE
5
Press OPERATION MODE SELECTOR
BUTTON
"
" on the right-hand of the malfunction
code blinks.
6
UP
DOWN
Press PROGRAMMING TIMER BUT-
TON and change the malfunction code.
Press until the indoor unit makes a long
beep.
The malfunction code is fixed when the
indoor unit makes a long beep.
MODE
7
Reset of the display
Press OPERATION MODE SELECTOR
BUTTON to get the display back to the
normal state.
"
$
TEMP
TIME
CODE
RESERVE CANCEL
UNIT N
.
O
II. IN CASE BESIDES EMERGENCY STOP
1. The unit does not operate at all.
• Check if the receiver is exposed of
sunlight or strong light. Keep receiver
away from light.
English
ON
OFF
"
UP
$
DOWN
FAN
TIMER
MODE
! #
%
SWING
/TEST
• Check if there are batteries in the
remote controller. Place the batteries.
• Check if the indoor unit number and
wireless remote controller number are
equal.
Operate the indoor unit with the remote con-
troller of the same number.
Signal transmitted from a remote controller of
a different number cannot be accepted. (If
the number is not mentioned, it is considered
as "1")
2. The system operates but it does not
sufficiently cool or heat.
• If the set temperature is not proper.
• If the FAN SPEED is set to LOW
SPEED.
• If the air flow angle is not proper.
Contact the place of purchase in the fol-
lowing case.
WARNING
When you detect a burning odor, shut
OFF power immediately and contact the
place of purchase. Using the equipment
in anything but proper working condition
can result in equipment damage, electric
shock and/or fire.
Number
Number
11
Advertisement
