Whirlpool R-92 Manual page 40

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
SERVICING THE HARNESS &
MOTOR CONNECTOR
Both the motor connector and the wire harness
are serviceable. To remove a wire from the
motor connector:
1. Use a small screwdriver or knife and lift
the wire retainer tab far enough to slide
the wire terminal out of the connector.
2. To install a wire terminal, position the
terminal with the slot facing the retainer
tab, and slide it into the connector. Press
down on the retainer tab to lock it in place.
Wire Terminal
Slot
Motor
Connector
5-16
Wire
Screwdriver
Retainer
Tab