Whirlpool R-92 Manual page 27

5. Open the freezer door and actuate the
freezer door switch 3 times. NOTE: This
step must be completed within 10 sec-
onds of opening the freezer door.
6. Close the freezer door within 20 seconds
of completing step 5.
7. Wait for a minimum of 5 seconds, and a
maximum of 50 seconds, then open the
freezer door, and view the status LED on
the infrared receiver module for the error
code. NOTE: You will have 60 seconds to
open the freezer door, and 2 seconds from
then to view the LED output code.
If the LED still flashes twice, there could be
dirt or frost on the optics, something could be
blocking the infrared beam path, or the optics
may be defective. Clean the optic elements and
repeat the previous test.
If the LED does not flash, the ice maker may
have been in a harvest, preventing the diag-
nostics from being performed. Look at the ice
maker to make sure the ejector is at the home
position. If it is, wait 3 minutes, and try running
test again. If the LED still does not flash, the
optics boards may be defective.
5-3