Whirlpool R-92 Manual page 18

c) Install a length of flexible tubing on the
spout of the squeeze bottle.
d) Insert the end of the flexible tubing into
the water fill nozzle as far as ice block-
age.
e) Squeeze the bottle and allow the hot
water to melt all of the ice.
Squeeze
Bottle
5. To reinstall the new tube:
a) Insert the end of the tube into the hole
of the freezer liner fitting, and push it
through as far as the nozzle will allow.
To prevent a water flow restriction, do
not twist the tube and nozzle assembly.
Pull the end of the tube at the rear of
the unit to take up any slack. NOTE: The
end of the tube may get caught on the
fitting at the back of the unit. If this hap-
pens, position the tube in the center of
the hole with a small screwdriver, and
push the tube the rest of the way
through from the front.
Fitting
Rear of Unit
Insert Flexible Tube
Into End Of Nozzle
Pull Tube
Out Here
4-4
b) Position the water fill nozzle so that the
bend is toward the mullion, and insert
the inner half of the grooved shoulder
into the square cutout of the liner.
Grooved Shoulder In Liner Cutout
c) Push the end of the tube into the water
line fitting as far as it will go, and then
pull on the tube to make sure that it is
secure.
Push Tube Into Fitting
Locking Ring
Water Line
Fitting
Rear of Unit
Water Nozzle