Denon AVRS650HOM Owner's Manual page 186

Contents Connections
No sound is produced from subwoofer.
Check the subwoofer connections.
0
Turn on the subwoofer's power.
0
Set "Speaker Config." – "Subwoofer" on the menu to "Yes". (v p. 155)
0
When "Speaker Config." - "Front" in the menu is set to "Large", depending on the input signal and the sound mode, no sound may be output from the
0
subwoofer. (v p. 154)
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the subwoofer. (v p. 159)
0
You can make the subwoofer always output sound by setting the "Subwoofer Mode" to "LFE+Main". (v p. 159)
0
DTS sound is not output.
Check that the digital audio output setting on the connected device is set to "DTS".
0
Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output.
Make HDMI connections. (v p. 38)
0
Check the digital audio output setting on the connected device. On some devices, "PCM" is set by default.
0
Dolby PLg mode or DTS Neo:6 mode cannot be selected.
It cannot be selected when "Speaker Config." - "Surround" is set for "None". (v p. 155)
0
Dolby PLg or DTS Neo:6 cannot be selected when using headphones.
0
Audyssey MultEQ ® , Audyssey Dynamic EQ
These cannot be selected when you have not performed Audyssey
0
Switch to a sound mode other than "Direct". (v p. 93)
0
These cannot be selected when using the headphones.
0
"Restorer" cannot be selected.
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
0
surround, "Restorer" cannot be used. (v p. 124)
Switch to a sound mode other than "Direct". (v p. 93)
0
Front panel Display
Playback
® and Audyssey Dynamic Volume
® Setup. (v p. 144)
186
Rear panel
Settings Tips
® cannot be selected.
Remote Index
Appendix