Install brackets.
Firmly press the toilet gasket onto the
toilet outlet of plastic trap.
NOTE 1:
Wax ring type toilet gasket
should not be installed at temperatures
o
less than 21 C.
NOTE 2:
If you are using a toilet
gasket with an integral plastic sleeve,
make sure the gasket is positioned
with the sleeve facing away from the
toilet.
Install plastic to ground and mounted
with 3 set of bolts firmly.
NOTE: Must use the toilet installation
gasket ring (not supplied) to seal the
area where the waste pipe contacts
the construction section to avoid
leakage.
Thread the supply hose onto the fill
valve shank.
Install the seat. Use the supplied
hardware pack for seat.
1318109-T01-C
Fig.#6
6
Plastic Trap Outlet
Toilet Gasket
Fig.#7
7
Fig.#8
8
Fig.#9
9
Fig.#10
10
-5-
1
o
21
C
2
3
)
(