Diagrams - Sony AIWA XR-MN5 Service Manual

• Circuit Boards Location
FAN board
FRONT board
SW (3) board
SW (2) board
SW (1) board
SENSOR board
SECTION 8

DIAGRAMS

MAIN board
PT board
CD-KEY board
HP board
SW (4) board
STOCKER MOTOR board
ROLLER MOTOR board
ST ENCODER board
CONNECTOR board
BD board
MODE MOTOR board
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1 / W or less unless otherwise
4
specified.
∗
: Impossible to measure
• : internal component.
f
• 2 : nonflammable resistor.
• 1 : fusible resistor.
• C : panel designation.
Note: Note:
The components identi- Les composants identifiés par
fied by mark 0 or dotted une marque 0 sont critiques
line with mark 0 are criti-
pour la sécurité.
cal for safety. Ne les remplacer que par une
Replace only with part piéce por tant le numéro
spécifié.
number specified.
• A : B+ Line.
• B : B– Line.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : Power on
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F : TUNER
J
: CD
d
: AUX
E
: PB (TAPE)
a : REC (TAPE)
c : DIGITAL OUT
• Abbreviation
AUS : Australian model.
CND : Canadian model.
SP : Singapore model.
TW : Taiwan model.
KR : Korean model.
TH : Thai model.
• Waveforms
– BD Board – – MAIN Board –
1
TP8 (RFAC)
1.2Vp-p
200mV/DIV, 1 µ s /DIV
2
IC101 us (XTAO)
3.3Vp-p
59.1ns (16.9MHz)
1V/DIV, 40ns /DIV
27 27
For printed wiring boards.
Note:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : internal component.
f
• : Pattern from the side which enables seeing.
Caution:
Pattern face side: Parts on the pattern face side seen from
(Conductor Side) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Component Side) the parts face are indicated.
• Indication of transistor
C
Q These are omitted.
B E
Q
B C E
These are omitted.
Q
B C E
These are omitted.
3
IC901 qd (CF2)
2.0Vp-p
115ns (8.64MHz)
1V/DIV, 40ns /DIV
4
IC901 q; (XT2)
1.9Vp-p
30.5 µ s (32.768kHz)
1V/DIV, 20 µ s /DIV
CX-LMN5
Ver 1.1 2003. 06