JVC GR-AX527UM Instructions Manual page 34

34
REW/FF CANCEL
To EDIT
Editing cable
(optional 3.5 ø
mini-plug cable)
C A
B
To Remote
PAUSE
To Pause-In
VCR (Recording deck)
ON/OFF
VCR REC STBY
CANCEL
IN/OUT
RM-V700U (optional)
IN OUT
1 0:00:25
2
3
4
5
6
7
8
COUNTER 0:00:25
TOTAL 0:00:00
2
IN/OUT
R.A. EDIT
PLAY/PAUSE
3
STOP
SELECT SCENES
1
To AUDIO and
VIDEO out
2
connector
Audio and Video
cable (optional)
3
To AUDIO and
VIDEO IN
connectors
4
5
NOTES:
The RM-V700U can be used to operate other camcorder
functions as well. Point the RM-V700U at the camcorder's
remote sensor and press any of the following buttons
(function appears in parentheses):
— ON/OFF (camcorder R.A. EDIT)
— IN/OUT (camcorder IN/OUT)
— CANCEL (camcorder CANCEL)
IN OUT
1 0:00:25 0:01:05
There must be at least one second between an in-point and
2 0:03:18 0:03:31
3 0:02:33 0:02:53 its corresponding out-point.
4 0:04:11
The camcorder prerolls during R.A. Edit, so there must be at
5
6
least 15 seconds of recording material prior to any in-point.
7
8
Blank portions of tape cannot be registered as in-points or
COUNTER 0:04:11
out-points.
TOTAL 0:01:13
If it takes more than 5 minutes to search for an in-point, the
VCR's Record-Pause mode is cancelled and editing doesn't
take place.
Pressing R.A.EDIT clears all in- and out-points from
memory.
Leave a small margin for error around each in-point to
ensure the scene is recorded in its entirety.
EDITING (cont.)
PREPARE CAMCORDER
Insert a recorded tape and set the power switch to
PLAY.
PREPARE VCR
Turn the power on, insert a recordable tape and
engage the AUX mode (refer to VCR's instructions).
ACCESS R.A. EDIT COUNTER
DISPLAY
Press PLAY/PAUSE, then press R.A. EDIT and the
counter display appears in the viewfinder and the
screen of the connected TV.
REGISTER BEGINNING OF SCENE
Press REW or FF to locate the beginning of a scene
you want, then press IN/OUT to register that point.
The data appears under IN on the display.
REGISTER END OF SCENE
Press REW or FF to locate the end of the scene and
press IN/OUT to register it. The data appears under
OUT on the display. The total time of the registered
scene(s) is displayed at the bottom of the screen.
REGISTER ADDITIONAL SCENES
Repeat steps 2 and 3 for each additional scene
(as many as 8).
MAKE CORRECTIONS
Press CANCEL during steps 2 and 3 to erase the
most recently registered point.