Table of Contents
Advertisement
1.
SAFETY AND SYSTEM PRECAUTIONS
1.1
Definition of the Safety Symbols
Before attempting any
service, please read the
manual
Warning:
Water cannot be used
to extinguish fire
Compressed air inlet connection
1 Only experienced and trained personnel familiar with all of the relevant laws, rules and regulations, capable to perform the needed activities
and to identify and avoid possible dangerous situations while handling, installing, using and servicing the machine.
1.2
Operational Warnings
WARNING: VESSELS UNDER PRESSURE
+ In most countries, states, cities and/or local municipalities the installation, operation and maintenance of
devices where pressure vessels are in use are subject to local boiler and pressure vessel regulations.
+ The end user is responsible for following all of the relevant laws, rules and regulations and ensuring that
only experienced and trained personnel install and/or operate the adsorber.
+ In most countries, states, cities and/or local municipalities the installation may only be carried out by
a licensed installation company. Inspections must be carried out by a qualified and licensed third-party firm in
accordance with all applicable laws, rules and regulations for the region where the adsorber is installed.
+ The pressure vessels used in this device are built according to the American Society of Mechanical
Engineers (ASME) standard Section 8, Division 1.
Compressed Air Warning:
Compressed air is a highly dangerous energy source.
+ Never work on the adsorber while components are under pressure.
+ Never point the compressed air stream or the condensate drain outlet towards anybody.
The end user is responsible for the installation of the adsorber as laid out in this manual. If proper commissioning
steps are not followed, the warranty will be void and dangerous situations involving injury or death and/or
damages to the machine could occur.
Only qualified personnel can use and service electrically powered devices. Before attempting any maintenance:
+ Ensure that no part of the machine is powered and is locked out of the electrical mains by following
proper "Lock-out, Tag-out" procedures and requirements.
+ Ensure that no part of the adsorber is under pressure by isolating the adsorber from the compressed air
system.
Any change to the machine or to the standard operating parameters (see page 5), if not previously verified and
authorized by the manufacturer, in addition to creating a potentially dangerous situation, will void the warranty.
CLEARPOINT V
5
General Warning:
Electrical Hazard:
Risk of damage or
Possibility of electro-
injury
Warning:
Do not operate if parts
Machine level noise
are missing or have
may exceed 85 dBA
been tampered with
Series Activated Carbon Tower
®
Warning:
Under pressure
cution
Warning:
Warning:
Personal pro-
tection required
Compressed air outlet connection
(Rev. D)
Warning:
High temperature
Non-breathable air
Warning:
Operations that can be
All work to be per-
performed by qualified
formed by qualified
personnel only
Connection point for condensate drain
Warning:
operators
1
Advertisement
Table of Contents
