Symbols; Features - RIDGID R862311 Operator's Manual

SYMBOLS

The following signal words and meanings are intended to explain the levels of risk associated with this product.
SYMBOL SIGNAL
DANGER:
WARNING:
CAUTION:
NOTICE:
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper inter-
pretation of these symbols will allow you to operate the product better and safer.
SYMBOL
Safety Alert
Read Operator's
Manual
Eye Protection
Wet Conditions
Alert
Recycle Symbol
V Volts
min Minutes
Direct Current
n o
No Load Speed
.../min Per Minute

FEATURES

PRODUCT SPECIFICATIONS
(R86115 Hammer Drill)
No Load Speed ..........................0-500/0-2,100/min. (RPM)
Impact Speed ................................0-7,500 / 0-31,500 BPM
MEANING
Indicates a hazardous situation, which, if not avoided, will result in death or
serious injury.
Indicates a hazardous situation, which, if not avoided, could result in death or
serious injury.
Indicates a hazardous situation, that, if not avoided, may result in minor or
moderate injury.
(Without Safety Alert Symbol) Indicates information considered important, but
not related to a potential injury (e.g. messages relating to property damage).
NAME
Indicates a potential personal injury hazard.
To reduce the risk of injury, user must read and understand operator's manual
before using this product.
Always wear eye protection with side shields marked to comply with ANSI
Z87.1.
Do not expose to rain or use in damp locations.
This product uses lithium-ion (Li-ion) batteries. Local, state or federal laws
may prohibit disposal of batteries in ordinary trash. Consult your local waste
authority for information regarding available recycling and/or disposal options.
Voltage
Time
Type or a characteristic of current
Rotational speed, at no load
Revolutions, strokes, surface speed, orbits etc., per minute
DESIGNATION/EXPLANATION
PRODUCT SPECIFICATIONS
(R862311 Impact Driver)
Speed ....................................................0-2,900/min. RPM
Low (1) ............................................0-900 RPM
Medium (2) ...................................0-2,000 RPM
High (3) ........................................0-2,900 RPM
Chuck ................................................................1/4 in. Hex
Impacts per minute ................................ 0-4,200/min. IPM
Torque ..........................................................0-2,300 in-lbs.
5 - English