Running A Product Check - Epson XP-5200 User Manual

LCD screen message
Check that the printer
driver is installed on the
computer and that the
port settings for the
printer are correct.
Check that the printer
driver is installed on the
computer and that the
USB port settings for the
printer are correct.
Recovery mode
Update Firmware
Note: The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages.
During the life of your product it may reach a condition where either satisfactory print quality cannot be
maintained or the ink pads have reached the end of their usable life. The Epson Status Monitor, your
LCD screen, or lights on the control panel will advise you when these parts need replacing. If this
happens during the standard warranty of the product, the exchange of the product or replacement of the
pads is covered under the standard warranty. If the product is out of warranty, the pads can be replaced
by any Epson authorized service provider. The waste ink pads are not a user-replaceable part.
Parent topic:
Related tasks
Using AirPrint
Accessing the Web Config Utility
Loading Paper in the Cassette
Related topics
Solving Paper Problems
Replacing Ink Cartridges and Maintenance Boxes
Wi-Fi Networking

Running a Product Check

Running a product check helps you determine if your product is operating properly.
Condition/solution
Make sure the printer port is selected correctly on the Port tab of the Printer
Properties screen (Windows) or the System Properties > USB list (Mac).
Select USBXXX for a USB connection or EpsonNet Print Port for a network
connection.
An error has occurred during firmware updating. Connect your product using
a USB cable and try updating the firmware again. If you still receive this error
message, contact Epson for support.
Solving Problems
203