Adjusting The Balance - Clarion compact disc Owner's Manual

While driving, keep the volume to a level at
which external sounds can be heard.
Turning on and off the monitor
Each time you press the MONI button
monitor is turned on and off.
While using the rear vision camera, monitor-off
*
mode is canceled. When a button other than the
ENT button , the TAPE button
11
ton , or CD button
2
mode is canceled.
Mute
Each time you press
button , mute is turned on and off.
11
"MUTE" is displayed when mute is turned on in
radio mode, and "PAUSE" is displayed in tape,
CD or CD changer mode.

Adjusting the balance

1) Press the A-M button
ANCE display.
CAUTION
Note:
• If no setting is made 5 seconds after pressing the A-
M button , the unit returns to the previous mode.
6
2) Slide the Up/Down button
(right), (up), or
balance of the speakers.
: Increases the volume of the left speaker.
: Increases the volume of the right speaker.
: Increases the volume of the front speaker.
: Increases the volume of the rear speaker.
3) Press the A-M button
vious mode.
The tone is adjusted with the equalizer. For
*
information on equalizer operation, see the
section "Operating the Equalizer."
Adjusting the operation panel to a
good viewing angle
, the
25
, SLOPE but-
1
is pressed, monitor-off
3
(center) of the ENT
to go to the BAL-
6
Balance of the front
and rear speakers
Balance of the left
and right speakers
11 to (left),
(down) to adjust the
to return to the pre-
6
Adjust the operation panel to an appropriate angle
to watch the display and operate the buttons.
SLOPE button 2
Do not place foreign objects in the Cassette
Insertion slot or the CD Insertion slot
30
When adjusting the angle of the panel, be care-
ful not to let your fingers get caught in the panel.
1) While the SLOPE button
operation panel tilts.
If you press and hold the SLOPE button
the panel turns upward to the maximum
angle and stops.
2) When the operation panel is set to the maxi-
mum angle, pressing the SLOPE button
closes the panel.
The operation panel angle can be stored. For
*
details, see the next subsection.
Notes:
• Do not place any object on the operation panel.
•
Do not expose the operation panel to shocks.
Storing the operation panel angle
When the operation panel angle is stored, it is
set to that angle after a CD or cassette tape is
inserted.
1) Press the SLOPE button
priate operation panel angle.
2) Press the ADJ button
FIGURATION display.
3) Slide the Up/Down button
(down) to move the cursor to "VIEW
ANGLE."
4) Press (center) of the ENT button
CD Insertion slot 31
.
31
is held down, the
2
2 ,
2
to set an appro-
2
10 to go to the CON-
to (up) or
11
.
11
15