Advertisement
SYMPTOM
POSSIBLE CAUSE
Light will not come
1. Light switch is turned off.
on.
2. Light bulb is loose or burned
out.
3. Fuse is blown or circuit breaker
is turned off.
4. Daylight turnoff is in effect (re-
check after dark).
5. Incorrect circuit wiring, if this is a
new installation.
6. Re-aim the sensor to cover de-
sired area.
Light comes on
1. Entryway Light may be installed
in daylight.
in a relatively dark location.
2. Entryway Light is in Test. (Set
control switch to an ON-TIME
position).
TROUBLESHOOTING GUIDE
SYMPTOM
POSSIBLE CAUSE
Light comes on
1. Entryway Light may be sensing small
animals or automobile traffic (re-aim
for no apparent
sensor).
reason.
2. Sensitivity is set too high. (Reduce
sensitivity).
Light stays on
1. Entryway Light is pointed toward a
continuously.
heat source like an air vent, dryer
vent, or brightly-painted heat-reflective
surface. (Reposition sensor).
2. Light control is in Manual Mode. (Switch
to Auto.)
Light flashes
1. Heat being reflected from other objects
may be affecting the sensor. (Reposi-
on and off.
tion sensor).
2. Entryway Light is in the Test mode and
warming up. (Flashing is normal under
these conditions).
Learn more about home shop we have.
Advertisement
