Connecting The Asi Bus (Logo - Siemens LOGO! 24RC Manual

2.2.4 Connecting the ASi Bus (LOGO! ...B11 Only)
This section will be of interest to you if you want
to connect LOGO!..B11 to the ASi bus.
LOGO!...B11
LOGO!...B11 can be integrated into a network as an ASi
slave. Using a two-wire lead you can then do the following:
Read in and process 4 additional inputs via the ASi bus.
Operate 4 additional outputs on one overlaid master of
the ASi bus.
Configure LOGO!...B11 in the ASi bus by means of the ASi
master you are using.
Prerequisites for operation on an ASi master
Please note: LOGO! ...B11 must be registered in the ASi
system (e.g. LOGO! is assigned an address by the bus
master). Please read Section 2.2.5 to find out how to do
this with LOGO!..
Caution
!
LOGO! Manual
A5E00067781 01
The ASi address can be changed at least
10 times for all LOGO! ..LB11 variants.
Additional changes are not guaranteed.
Installing and Wiring LOGO!
21