Jig For Servicing - Denon PMA-1600NE Service Manual

CAUTION IN SERVICING.
Initializing This Unit
Make sure to initialize this unit after replacing the microcomputer or any peripheral equipment, or the
PCB.
1. Press the power button to turn off the power.
2. While holding down the "ANALOG MODE" button, press the power button to turn on the power.
3. Display and LED All Lighting.
4. This mode is canceled when the power is turned off.
NOTE： • If the unit fails to enter the service mode in step 3, repeat the procedure from step 1.
• Initializing the device restores the customized settings to the factory settings. Write down
your settings in advance and reconfigure the settings after initialization.
X ANALOG MODE

JIG FOR SERVICING

The jig (RS-232C > product internal connector conversion board + 7P Cable Kit) used for firmware up-
dates is as shown below.
Order with your dealer for the jigs your dealer if necessary.
8U-210100S : WRITING KIT : 1 Set
606050028012P : 7P FFC (straight) : 1 Set
(See "FIRMWARE UPDATE PROCEDURE")
8