Adjusts The Vox Anti-Trip Sensitivity; Phones Jack; Mic; Main Dial - Yaesu FT-710 Operation Manual

• Adjusts the VOX anti-trip sensitivity

The Anti-Trip setting sets the negative feedback
of receiver audio to the microphone, to prevent re-
ceiver audio from activating the transmitter (via the
microphone).
1. Press the [FUNC] knob.
2. Touch [ANTI VOX] .
3. Rotate the [FUNC] knob to prevent receiver au-
dio from activating the transmitter (via the micro-
phone).
MOX
Press and hold this key engages the PTT (Push to
Talk) circuit to activate the transmitter.

PHONES Jack

Connect headphones to this standard ϕ3.5 stereo
jack.
Inserting a headphone plug into this jack will deacti-
vate the internal and external speakers.
When wearing headphones, we recommend
that you turn the AF Gain levels down to
their lowest settings before turning power
ON, to minimize the impact on your hearing
caused by audio "pops" during switch-on.
AUDIO (VFO-A/B)
AUDIO (VFO-A/B)

MIC

This 8-pin jack accepts input from a microphone uti-
lizing the traditional YAESU HF transceiver pinout.
GND
DOWN
UP
+5V
MIC GND
MIC
PTT
GND
FAST

MAIN dial

The MAIN dial sets the operating frequency.
Rotate the MAIN dial knob to tune within the band,
and begin normal operation.
● The amount of frequency change depends on the
operation mode (default setting: see table below).
Operating Mode
LSB / USB
CW-L / CW-U
DATA-L / DATA-U
RTTY-L / RTTY-U
PSK
AM / AM-N
FM / FM-N
DATA-FM / D-FM-N
"[FINE]" & "[FAST]" settings are ON. (These settings may
be changed in the Setting Menu.)
SSB/CW mode
"SSB/CW DIAL STEP"
RTTY/DATA mode
"RTTY/PSK DIAL STEP"
Adjusting the Main tuning DIAL torque
The torque (drag) of the Main DIAL knob may be
adjusted for operating preferences. Slide the lever
on the bottom side of the transceiver clockwise to
reduce the drag, or counter-clockwise to increase
the drag.

WIRE STAND

The heavy wire stand on the bottom of the
transceiver allows the transceiver to be tilted
upward for better viewing. Simply fold the
stand forward to raise the front of the trans-
ceiver, and fold it back against the bottom
case to lower the front of the FT-710.
1 Step 1 Dial Rotation
20Hz 4kHz
[1Hz] [200Hz]
(100Hz) (40kHz)
10Hz 2kHz
[1Hz] [200Hz]
(100Hz) (20kHz)
100Hz 20kHz
[10Hz] [2kHz]
(1kHz) (200kHz)
31