Hyundai Elantra N Owner's Manual page 159

Convenience Features
1) Programming Preparation
1. When programming a garage door
opener, it is advised to park the
vehicle outside of the garage.
2. It is recommended that a new battery
be placed in the handheld transmitter
of the device being programmed to
HomeLink for quicker training and
accurate transmission of the radio-
frequency signal.
3. Set the Engine Start/Stop button
to the ACC (Accessory) position for
programming of HomeLink.
5-38
2) Programming a New HomeLink®
OCN7050084N
1. Press and release the HomeLink
button (1), (2) or (3), you would like
to program. The HomeLink indicator
light (7) will flash orange slowly (if
not, perform the steps of "Erasing
HomeLink Buttons" section, and start
over).
2. Position the garage door opener
remote 1 – 3 inches (2 – 8cm) away
from the HoleLink buttons.
OCN7N051214N
OCN7N051215N