Table of Contents
Advertisement
v Configure the BladeCenter unit
v Update and configure BladeCenter components including the QS22 blade server
v Monitor the current system status
v Check the event log for system and other errors
Using the Web interface
Complete the following steps to start the Web-based management and configuration
program:
1. Open a Web browser. In the address or URL field, type the Internet protocol (IP)
2. Type your user name and password. Before you log in to the Advanced
3. Follow the instructions that appear on the screen. Be sure to set the timeout
The BladeCenter management and configuration window opens.
For additional information, see the IBM BladeCenter Advanced Management
Module User's Guide.
Using the command-line interface
The IBM BladeCenter Advanced Management Module also provides a
command-line interface to provide direct access to BladeCenter management
functions. You can use this as an alternative to using the BladeCenter Management
Module Web interface.
Through the command-line interface, you can issue commands to control the power
and configuration of the blade server and other components in the BladeCenter
unit. For information and instructions, see the IBM BladeCenter Management
Module Command-Line Interface Reference Guide.
Using Serial over LAN
To establish a Serial over LAN (SOL) connection to the blade server, you must
configure the SOL feature for the blade server and start an SOL session as
described in theIBM BladeCenter Serial over LAN Setup Guide. In addition, the
Advanced Management Module must be configured as described in the IBM
BladeCenter Management Module User's Guide, and the BladeCenter unit must be
configured as described in the IBM BladeCenter Serial over LAN Setup Guide.
40
BladeCenter QS22 Type 0793: Installation and User's Guide
address or host name that is assigned for the Management Module remote
connection. The default IP address is:
192.168.70.125
The Enter Network Password window opens.
Management Module for the first time, contact your system administrator
regarding whether your organization has assigned a user name and password
to you. Use the initial (default) user name and password the first time that you
log in to the Advanced Management Module. If you have an assigned user
name and password, use them for all subsequent logins. All login attempts are
documented in the event log.
The initial user ID and password for the Advanced Management Module are:
User ID
USERID (all capital letters)
Password
PASSW0RD (note the number zero, not the letter O, in PASSW0RD)
value that you want for your Web session.
Advertisement
Table of Contents
