Sending Route; Receiving Route; Goto Function; Goto Cursor - Interphase Chart Master Chart Master 11 CVS+ User Manual

[MENU] + "MENU" + [ENTER] +"ROUTE" + [ENTER] + "REPORT" + [ENTER]
+ [L ]
OCATE
The Route Report page is closed and the chart is centered over the first Waypoint
of the selected Route.

Sending Route

To transmit the Active Route information onto the NMEA output port.
[MENU] + "MENU" + [ENTER] +"ROUTE" + [ENTER] + "SEND" + [ENTER]
The NMEA WPL & RTE messages are sent to the output port.

Receiving Route

To save Route information received from the NMEA input port.
[MENU] + "MENU" + [ENTER] +"ROUTE" + [ENTER] + "RECEIVE" + [ENTER]
The received route is saved on the Active route, overwriting it. The NMEA WPL &
RTE messages are sent to the input port.
3.3

GOTO FUNCTION

This functions allows you to place the destination point and immediately start
navigating to it.

Goto Cursor

Place the cursor on the desired location + [GOTO] + "CURSOR" + [ENTER]
The destination is placed at the cursor position and you are now navigating to it.
It is a temporary User Point that will be removed when the navigation is stopped.
If the fix is received, the destination is placed on the desired location, otherwise
a warning message is shown. If the destination is already placed, it is possible to
remove the existing destination and place a new one on the cursor position.

Goto Mark on the Chart page

Place the cursor on any existing Mark + [GOTO]

Goto Mark using the User Points List

[GOTO] + "MARK" + [ENTER] + select the desired User Point + [GOTO]

Goto Route using the Select Route menu

[GOTO] + "ROUTE" + [ENTER] + select one of the existing Routes + [ENTER]/
[GOTO]
The destination is placed on the first Waypoint of the selected route and then the
Route Following function is activated.

Stopping Navigation

If the destination has been placed, to remove it:
[GOTO] + [D
otherwise, to remove the current destination and place a new one at cursor position:
Place the cursor on location to navigate to + [GOTO] + [N
3.4

USING TRACK

A very useful feature of the chart plotter, is the ability to store and display exactly
where the boat has been. This feature, referred to as Tracking, can provide in-
valuable information about the effect of tide and wind influence on the boat's
progress as well as giving an indication of the helmsman's performance.
When this limit has been reached, the oldest points are deleted and overwritten
by the newest ones.
24
]
ELETE
] + [ENTER]
EW
User Manual