Intermec EasyCoder PD4 Programmer's Reference Manual page 54

Chapter —Commands
The following QR Code bar code specific options should append
the general part of the two-dimensional code command (indi-
cated by italic characters, see b command, general part).
Syntax
bp
1
Parameters
c
m
o
s
x
y
"DATA"
If data not suitable to optional parameters: Error 01; Syntax error
Errors
If data too long or out of range:
If data does not fit in area specified
4 ESim v5.12 for EasyCoder PD4—Programmer's Reference Manual
,p ,p ,[cn,mn,on,sn,xn,ynn],"DATA"
2 3
Fixed data mode character set:
1 Numerical data mode
2 Alphanumerical data mode
3 8-bit data mode (JIS 0201)
4 Kanji data mode (JIS 0208)
5 Mixing mode (any of mode c1-c4, model type 2)
Default: Model 1
Model 2
Internally during rendering the QR Code, the mode can be switch within a bar
code to minimize the bit stream area. By using parameter cn, the data mode
character set is fixed.
Model type is defined and unchanged within one QR Code.
1 Original version
2 Enhanced version (recommended). Default.
Rotation:
0 0° rotation clockwise. Default.
1 90° rotation clockwise.
2 180° rotation clockwise.
3 270° rotation clockwise.
Sets correction level.
L 7 % Default.
M 15%
Q 25%
H 30%
Masking factor 0-7 or 8 (auto).
Default: 8
Cell pixel size magnification 02-64.
Default: 10
Represents a fixed data field. Maximum data length is relative chosen model
type and data mode but is limited to approximately 780 bytes. Ordinary string
controls, like \\ for \ and \" for ".
Most optimal alternative of c1 to c4
c5
Error 03; Data length
error
Error 50