Chapter 3 — Fingerprint Control
Activating the Cutter
The cutter is activated by CUT or CUT ON statements, see the Intermec
Fingerprint v8.xx, or the Intermec Direct Protocol v8.xx manuals. Applica-
tion programs may have related facilities for operating the cutter.
Controlling the Cut Position
The edge will cut through the media approx. 33 mm (1.3 inches) in front
of the printer's dot line. The relation between the media and the actual
cutting position is controlled by the Feed Adjustment parameters in the
Setup Mode or in setup files or setup strings.
The following feed adjustment values are recommended for cutting:
Type of Cutting
Cut between labels
Start adjust:
Stop adjust:
Cut between labels and print from leading edge on next label
Start adjust:
Stop adjust:
Cut variable length strip (no liner!)
Start adjust:
Stop adjust:
10
8 dots/mm printhead
± 0 dots
+ 160 dots
- 250 dots
+ 160 dots
- 250 dots
+ 275 dots
Cutter Kit (EasyCoder PF4i-series) Installation Instructions
11.81 dots/mm printhead
0 dots
+236 dots
-369 dots
+236 dots
-369 dots
+406 dots