Intermec EasyCoder PF2i Install Manual page 7

• Fit the sensor and bracket to the lug at the printer's front while rout-
ing the cable between the two rails on the center section and through
the slot in the center section as illustrated below.
Mounting lug
Sensor
Bracket
#T10 Torx screw
• Connect the LTS cable to J53 at the lower edge of the CPU board.
The connector is marked "LTS."
• Put back the bottom plate.
• Put the printer back on its feet and connect the power cord and all
communication cables.
Label Taken Sensor Kit Installation Instructions
Chapter 1 — Physical Installation
Center section
Cable to J53
on CPU board
3