Intermec EasyCoder 501 SA Installation Instructions Manual page 3

EasyCoder 501/601 – Installation Instructions
INDUSTRIAL INTERFACE KIT, cont'd.
Step-by-Step Installation
Instructions
Power
Switch
Power Cord
Receptacle
The only tool required is a Torx #T10 screwdriver.
Turn off the power and remove the power cord.
Remove the communication cable from communication port
"uart1:".
Open the right hand door.
Remove the eight Torx screws that hold the cover over the left
part of the printer (see illustration below).
Remove the cover.
Cover
Screws (4x)
0
230V
Communication
Port "uart1:"
Screws (4x)
Continued!
2