Table of Contents
Advertisement
Transmitter/Receiver Learn Routine
The system comes with two transmitters that have been taught to the receiver. The receiver can store
up to four different transmitter codes in memory. Use the following learn routine to add trans-
mitters to the system or to change button assignments if desired.
If the system was previously programmed using the 998T Bitwriter
locked. If the siren generates one long chirp when attempting to program the unit, the learn routine
is locked and must be unlocked using the 998T Bitwriter
O O p p e e n n a a d d o o o o r r . . (The H1/5 GREEN wire or the H1/7 VIOLET wire must
1.
be connected.)
2.
K K e e y y . . Turn the ignition ON. (The heavy-gauge PINK wire of the relay
satellite must be connected.)
3.
S S e e l l e e c c t t t t h h e e r r e e c c e e i i v v e e r r C C h h a a n n n n e e l l . . Press and release the integrated LED/Valet
switch the number of times necessary to access the desired channel. Once
you have selected a channel, press and HOLD the integrated LED/Valet
switch once more. The siren will chirp and the LED will blink the
number of times corresponding to the channel that has been accessed.
NOTE: If adding a remote, a button must be taught to the unit in the Channel One or Channel
Five position prior to programming other channels.
4.
P P r r e e s s s s t t h h e e t t r r a a n n s s m m i i t t t t e e r r b b u u t t t t o o n n . . While holding the integrated LED/Valet
switch, press the button from the transmitter that you wish to assign to
that channel. The unit will chirp indicating successful programming. It is
not possible to teach a transmitter button to the system more than once.
5.
R R e e l l e e a a s s e e . . Once the code is learned, the integrated LED/Valet
be released
©
2003
Directed Electronics, Inc.
, the learn routine may be
®
.
®
®
®
®
switch can
®
31
Advertisement
Table of Contents
