In Case Of Difficulty; Error Displays - Clarion DXZ735MP DXZ735MP DXZ735MP Owner's Manual

9. IN CASE OF DIFFICULTY

Problem Cause
Power does not Fuse is blown.
turn on.
(No sound is
produced.) Incorrect wiring.
No sound output Power antenna lead is
when operating shorted to ground or
the unit with excessive current is required
amplifiers or for remote-on the amplifiers
power antenna or power antenna.
attached.
Nothing happens The microprocessor has
when buttons are malfunctioned due to noise,
pressed. etc.
Display is not
accurate.
DCP or main unit connectors
are dirty.
No sound heard The speaker protection
circuit is operating.
No sound heard MP3/WMA files are absent in
a disc.
Files are not recognized as
an MP3/WMA file.
File system is not correct.
Sound skips or is Compact disc is dirty.
noisy.
Compact disc is heavily
scratched or warped.
Sound is cut or MP3/WMA files are not
skipped.
encoded properly.
Noise is
generated or
noise is mixed
with sound.
Sound is bad
Water droplets may form on
directly after the internal lens when the
power is turned
car is parked in a humid
on. place.
Wrong filename File system is not correct.
Play list play is File name or extension is not
not performed. correct.
28
DXZ735MP
Measure
Replace with a fuse of the same amperage. If the
fuse blows again, consult your store of purchase.
Consult your store of purchase.
1. Turn the unit off.
2. Remove all wires attached to the power antenna
lead. Check each wire for a possible short to
ground using an ohm meter.
3. Turn the unit back on.
4. Reconnect each amplifier remote wire to the
power antenna lead one by one. If the amplifiers
turn off before all wires are attached, use an
external relay to provide remote-on voltage
(excessive current required).
Turn off the power, then press
Reset button
the [OPEN] button and re-
move the DCP.
Press the reset button for
about 2 seconds with a thin
rod.
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol.
1. Turn down sound volume. Function can also be
restored by turning the power off and on again.
(Speaker volume is reduced automatically when
the speaker protection circuit operates).
2. If the sound is muted again, consult our service
department.
Write MP3/WMA files onto the disc properly.
Use MP3/WMA files encoded properly.
Use ISO9660 level 1, 2, 3 or JOLIET or Romeo file system.
Clean the compact disc with a soft cloth.
Replace with a compact disc with no scratches.
Use MP3/WMA files encoded properly.
Let dry for about 1 hour with the power on.
Use ISO9660 level 1, 2, 3 or JOLIET or Romeo file system.
Use alphanumeric/ASCII characters for MP3/WMA file name.
Use ".M3U" or ".ASX" for the file extension of a play list.

10. ERROR DISPLAYS

If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
Error Display Cause
ERROR 2 A CD is caught inside the CD deck and is
not ejected.
ERROR 3 A CD cannot be played due to scratches,
etc.
ERROR 6 A CD is loaded upside-down inside the
CD deck and does not play.
ERROR 2 A CD inside the CD changer is not
loaded.
ERROR 3
A CD inside the CD changer cannot be
played due to scratches, etc.
ERROR 6
A CD inside the CD changer cannot be
played because it is loaded upside-down.
ERROR H Displayed when the temperature in the
MD changer is too high and playback has
been stopped automatically.
ERROR 2 An MD inside the MD changer is not
loaded.
ERROR 3 An MD inside the MD changer cannot be
played due to scratches, etc.
ERROR 6 An MD inside the MD changer cannot be
played because it is loaded upside-down.
Displayed when a non-recorded MD is
loaded in the MD changer.
Measure
This is a failure of CD deck's mechanism
and consult your store of purchase.
Replace with a non-scratched,
non-warped-disc.
Eject the disc then reload it properly.
This is a failure of CD changer's
mechanism and consult your store of
purchase.
Replace with a non-scratched, non-
warped disc.
Eject the disc then reload it properly.
Lower the surrounding temperature and
wait for a while to cool off MD changer.
This is a failure of MD changer's
mechanism and consult your store of
purchase.
Replace with a non-scratched, non-
warped disc.
Eject the disc then reload it properly.
Load a pre-recorded MD in the MD
changer.
29
DXZ735MP