Advertisement
Available languages
Available languages
tool could be hazardous. To reduce the
E
risk of injury, only DEWALT recommended
accessories should be used with this product.
If you need any assistance in locating any accessory,
please contact your nearest D
go to www.DEWALT.com.
Target Card
Some laser kits include a Laser Target Card (Figure
to aid in locating and marking the laser beam. The
target card enhances the visibility of the laser beam as
the beam crosses over the card. The card is marked
with standard and metric scales. The laser beam
passes through the red plastic and reflects off of the
reflective tape on the reverse side. The magnet at the
top of the card is designed to hold the target card to
ceiling track or steel studs to determine plumb and level
positions. For best performance when using the Target
Card, the D
WALT logo should be facing you.
e
Laser Enhancement Glasses
Some laser kits include Laser En hancement Glasses
(Figure
). These glasses improve the visibility of
N
the laser beam under bright light conditions or over
long distances when the laser is used for interior
applications. These glasses are not required to operate
the laser.
CAUTION:
These glasses are not ANSI approved
safety glasses and should not be used while
operating other tools. These glasses do not
keep the laser beam from entering your eyes.
CAUTION:
To reduce the risk of serious injury, never stare
directly into the laser beam with or without
these glasses.
20
WALT service center or
E
)
M
Ceiling Mount
The laser ceiling mount (Figure
more mounting options for the laser. The ceiling mount
has a clamp (Figure
) at one end which can be fixed
L 2
to a wall angle for acoustic ceiling installation (Figure
). At each end of the ceiling mount is a screw hole
L 3
(Figure
and
), allowing the ceiling mount to
L 4
L 5
be attached to any surface with a nail or screw.
Once the ceiling mount is secured, its steel plate
provides a surface to which the magnetic pivot bracket
(Figure
) can be attached. The position of the
L 6
laser can then be fine-tuned by sliding the magnetic
pivot bracket up or down on the wall mount.
Service and Repairs
NOTE: Disassembling the laser level(s) will void all
warranties on the product.
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by
authorized service centers. Service or maintenance
performed by unqualified personnel may result in a risk
of injury. To locate your nearest D
call 1-800-4-DEWALT (1-800-433-9258) or go to www.
DEWALT.com.
Warranty
Go to www.DEWALT.com for the latest warranty
information.
), if included, offers
L 1
WALTservice center
E
Advertisement
