Advertisement
Available languages
Available languages
Mark the center of the beam at three locations
4.
E
(
,
,
) on the floor along the side laser line.
a
b
c
Mark
should be at the midpoint of the laser line
b
(Figure
).
G 1
Pick up and move the laser to
5.
Press
to turn on the front vertical beam too
6.
(Figure
).
G 2
Position the front vertical beam so it crosses
7.
precisely at
, with the side beam aligned with
b
(Figure
).
G 2
Mark a location
8.
e
least 14' (4m) away from the unit (Figure
Rotate the laser 90º so the side vertical beam now
9.
passes through
b
Directly above or below
10.
vertical beam.
Measure the distance between
11.
measurement is greater than the values shown
below, the laser must be serviced at an authorized
service center.
Distance from
to
a
b
14'
17'
20'
23'
Distance from
to
a
b
4.0 m
5.0 m
6.0 m
7.0 m
18
.
b
along the front vertical beam at
G 2
and
(Figure
).
e
G 3
, mark
along the front
f
a
and
. If the
a
f
Allowable Distance
Between
and
a
f
5/32"
3/16"
7/32"
1/4"
Allowable Distance
Between
and
a
f
3.5 mm
4.4 mm
5.3 mm
6.2 mm
Using the Laser
Leveling the Laser
As long as the laser is properly calibrated, the laser is
self-leveling. Each laser is calibrated at the factory to
find level as long as it is positioned on a flat surface
within average ± 4° of level. No manual adjustments
are required.
If the laser has been tilted so much that it cannot
c
self-level (> 4°), the laser beam will flash. There are
two flashing sequences associated with the out of level
condition.
).
• Between 4° and 10° the beams flash with a constant
blink cycle
• At angles greater than 10° the beams flash with a
three blink cycle.
When the beams flash THE LASER IS NOT LEVEL
(OR PLUMB) AND SHOULD NOT BE USED FOR
DETERMINING OR MARKING LEVEL OR PLUMB.
Try repositioning the laser on a more level surface.
Using the Pivot Bracket
The laser has a magnetic pivot bracket (Figure
permanently attached to the unit.
WARNING:
Position the laser and/or wall mount on
a stable surface. Serious personal injury or
damage to the laser may result if the laser
falls.
• The bracket has a fine adjustment knob (Figure
) to help you line up the laser beams. Place the
H 2
unit on a flat level surface and turn the knob to the
right to move the beams to the right, or turn the knob
to the left to move the beams to the left.
• The bracket has a keyhole slot (Figure
be hung from a nail or screw on any kind of surface.
)
H 1
) so it can
I
Advertisement
