Table of Contents
Advertisement
en Troubleshooting
18 Troubleshooting
WARNING
Risk of electric shock!
Incorrect repairs are dangerous.
Only use genuine spare parts when repairing the appliance.
▶
If the power cord of this appliance is damaged, it must be replaced by the
▶
manufacturer, the manufacturer's Customer Service or a similarly qualified
person in order to prevent any risk.
Fault
Creasing.
Spin noise during the
drying phase.
The drying time is too
long.
Odours have formed
in the appliance.
The display goes out
and Start / Pause
flashes.
"E:18"
36
Cause and troubleshooting
The load is too large.
The laundry lies in the drum for too long after drying.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Unsuitable programme for the type of fabric.
Set the suitable programme for the type of fabric.
▶
Easy-Care fabrics are dried for too long.
Thermal spinning is active.
The ambient temperature is greater than 30 °C.
Ensure that the ambient temperature is lower than
▶
30 °C.
Insufficient air circulation at the appliance's installation
location.
Ventilate the appliance's installation location.
▶
Fluff has accumulated in the drum.
Run the Drum Clean
▶
laundry or detergent.
Humidity and detergent residue may promote the
formation of bacteria.
→ "Cleaning the drum", Page 32
▶
If you are not using the appliance, leave the door
▶
and detergent drawer open so that residual water
can evaporate.
Energy-saving mode is active
Press any button.
▶
a The symbol lights up again.
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
programme without any
Advertisement
Table of Contents
