Toshiba RAV-HM301MUT-E Service Manual page 33

No. Item
12 Louver control 1) Louver position setup
2) Swing setup
3) When the unit stopped or the warning was output, the louver is
4) When PRE-HEAT
<<Individual air direction setup>>
(In the case of RBC-AMTU3∗)
•
• In case of no input (key operation) for approx. 5 seconds during
• For the air direction illustration during normal operation, the air
• While individual air direction is being set,
• When selecting a case,
* For RBC-AMSU5∗ remote controller,
Outline of specifications
• When the louver position is changed, the position moves
necessarily to downward discharge position once to return to
the set position.
• The louver position can be set up in the following operation
range.
In cooling/dry operation
• In group twin operation, the louver positions can be setup
collectively or individually.
• [SWING] is displayed and the following display is repeated.
In all operations
• In group operation, the louver positions can be set up
collectively or individually.
automatically set to full closed position.
(Heating ready) is displayed
(Heating operation started or defrost operation is performed),
heating thermo is off or self-cleaning is performed, the louver is
automatically set to horizontal discharge position.
* The louver which air direction is individually set or the locked
louver closes fully when the unit stops and the louver is
automatically set to horizontal discharge position when PRE-
HEAT (Heating ready) is displayed, heating thermo is off.
UNIT LOUVER
Pushing Louver select button enables every discharge
port to set up the air direction.
The louver numbers that are displayed on the display part
correspond to those in the following figure.
setting of individual air direction (during displaying of louver No.
on the remote controller screen), the remote controller screen
returns to the normal display screen.
direction of the least No. among the louvers which are block-set
is displayed.
the remote controller operation
(Illustration of air direction) and
operation of the real machine are linked.
UNIT
select button is not pushed or louver No.
is not displayed, the air directions of all
the louvers are collectively set up.
refer to its owner's manual.
In heating/fan operation
(Repeats)
LOUVER
Louver
04
Drain pipe
– 33 –
Remarks
The swinging louver
moves usually up to the
ceiling side from the
louver position of the set
time.
Setup from the remote
UNIT LOUVER
controller without
button is unavailable.
03
02
01
Refrigerant pipe