Table of Contents
Advertisement
INSTALLATION
CART ASSEMBLY INSTRUCTIONS
STEP 2
Outdoor Appliance Head Preparation
1. First you will need to remove the angle brackets from the side
of the unit and replace them with cart mount brackets
(Fig. 04). Unit is shipped prepared for island installation.
2. Install the Bracket Tab on both sides using 8 of the
10-24 x 12mm screws. Install each bracket with 4 screws on
each side of the grill head (Fig. 04, 05 and 06). For a CAD-48,
use the appropriately labeled bracket for your grill head and cart
side.
Fig. 05
Note:
For the CAD-48 there are two sets of brackets. If you have the BGB48-BQR, use the brackets labeled LEFT-48 BQR and
RIGHT-48 BQR. If you have the BGB48-BQAR, use the brackets labeled 48 BQAR.
5
SCREWS
Fig. 04
SCREWS
Fig. 06
Advertisement
Table of Contents
