Controls Menu - InFocus LP930 User Manual

Controls Menu

Display Audio Image
Video Standard
When Video standard is set to Auto, the projector attempts to
pick the video standard (NTSC, NTSC 4.43, PAL, PAL-M, PAL-
N,PAL-60, or SECAM) automatically based on the input signal it
receives. (The video standard options may vary depending on
your region of the world.) The input signal for SECAM video is
similar to other video signals and cannot be automatically
detected, therefore SECAM must be chosen manually. If the pro-
jector is unable to detect the correct standard, the colors might
not look right or the image might appear "torn." If this happens,
manually select a standard by clicking the left or right mouse but-
ton and cycling through the standards.
Standby Time
This option lets you select how long the lamp stays on and the
blank screen is displayed when the projector enters standby
mode before the projector turns off. Select among instant, 1, 5, 10,
15 and 30 minutes and 1 and 2 hours by clicking the left or right
mouse button and cycling through the options.
Controls Language
> >
Video standard
Standby time
Ceiling projection
Rear projection
Default source
Auto source select
Plug and Play
USB: Mouse Button
USB: Inhibit Screen Saver off
Display messages
Display startup screen
Status
1 minute
off
off
computer VESA
off
off
left/right
on
on
F 26
IGURE
Controls menu
NOTE: If you already know the
video standard used in your geo-
graphical area, it's often best to
manually select it.
35