Fisher & Paykel CLEANSMART 7 Series Installation Manual/User Manual page 45

Wash problems
PROBLEM
Wash cycle time
longer than usual
Small amount of
water in bowl at end
of cycle
Liquid remaining in
fabric softener and/or
wash boost dispenser
at end of cycle
Creasing
TROUBLESHOOTING
POSSIBLE CAUSES
If water pressure is low, cycle
time will increase due to longer
fill times.
The out of balance automatic
recovery setting may be selected
(ie Automatic Recovery is ON).
Wash cycle time is approximate
and may be affected by a
number of factors.
A small amount of water may
discharge from the fill nozzle
after wash.
option may not have
SOFTENER
been selected.
After flushing of dispensers,
a small amount of water may
remain in the dispenser at the
end of the cycle.
Dispensers may be blocked.
Overloading of the washer.
Inappropriate cycle selection.
Spin speed too high.
Wash temperature too high
for items.
Other.
WHAT TO DO
Ensure that inlet hose filters are
not blocked.
Refer to 'Changing pre-set options'.
Refer to 'Wash cycles'.
This is normal.
Check next time if you wish for softener to
be dispensed that the
is selected.
This is normal.
Try cleaning your fabric softener and/
or wash boost dispenser to remove any
blockages, refer to 'Caring for your washer'.
Try reducing load size.
Choose or
EASY IRON
as these cycles have been designed to
minimise creasing.
Try selecting a lower spin speed.
Try selecting a lower wash temperature.
Sort your load so that items of similar
weight are washed together.
Do not leave wet clothes to sit in the
washer or laundry basket.
option
SOFTENER
cycle
HANDWASH
45