Table of Contents
Advertisement
PROBLEM
DISPLAYED AS
The washer is
out of balance.
The washer has
too many suds.
The lid can't
lock or the lid is
open.
The washer is
overloaded.
The washer has
stopped.
The washer has
stopped.
BEFORE YOU CALL FOR SERVICE
WHAT TO DO
Wash load is out of balance. Ensure the washer is stationary.
Manually redistribute the load.
Check the washer is level, refer to 'Installation instructions -
Levelling instructions'.
The washer has a suds build-up (too much detergent may have
been used for the amount of soil in the load). Wait for suds to
dissolve (about 20 min). Rinse clothes using a deep rinse.
Check the standpipe height does not exceed 1200 mm.
If using the
placed in the detergent dispenser.
If the symptom persists, call your Fisher & Paykel dealer or
Authorised Repairer.
Make sure the lid is closed.
Touch
If the symptom persists call your Fisher & Paykel dealer or
Authorised Repairer.
The washer is overloaded and cannot agitate. Ensure the
washer is stationary. Remove items until the remaining ones can
move freely.
Check that the washer is not siphoning, refer to 'Installation
instructions - Draining'.
The power was cut to the washer. The washer will restart
automatically. No action is required.
The
minutes. The washer will automatically drain to a safe level. Touch
any button to stop autodraining then touch
wash cycle.
option, reduce the amount of detergent
DUAL WASH
. Refer to 'Lid lock'.
or
was touched and the washer was inactive for 3
to resume the
41
Advertisement
Table of Contents
