Advertisement
WARNING
The charger is intended for charging lead acid and lithium (LiFePO4) batteries. Do not use for
other purposes. Do not charge non-rechargeable batteries. Do not charge frozen batteries.
This appliance should not be used by persons (including children - under 8 years of age) with
reduced physical, sensory or mental capabilities, or without sufficient knowledge and experience,
unless they are supervised and have received adequate instructions.
Keep away from children. This appliance should not be used as a toy.
Always wear protective goggles and protect your face from the battery during connection and
disconnection.
Explosive gases may be emitted when charging the battery, so avoid sparks or flames and do not
smoke.
Charge in properly ventilated and dry environments: do not expose to rain or snow.
Make sure that the charger is disconnected from the mains before connecting, or disconnecting,
the charging cables to the battery.
When charging never place the charger over the battery.
The liquid inside the batteries is corrosive, if there is accidental contact of the acid with the skin or
eyes rinse immediately with water and seek medical advice.
The improper use of the charger, or the tampering of the electronic circuit inside the device, will
void the warranty.
In case of damage, the power cord of the appliance must be replaced by authorized technicians,
since intervention requires the use of special tools.
Repair or maintenance of the appliance must be carried out only by qualified personnel.
Use the charger only after carefully reading the instruction manual.
CHARGING
Charging batteries connected to the vehicle
1.
Before starting ensure that the power cord is disconnected from the mains socket.
2.
Locate the vehicles main earth point; generally connected to the negative terminal of the battery.
3.
Connect the output lead with red clamp to the positive (+) pole of the battery.
4.
Connect the output lead with black clamp to the ground of the vehicle, away from the battery and
any fuel lines.
5.
Use of eyelet terminals.
- Connect the black eyelet output lead to the negative (-) terminal of the battery.
- Connect the red eyelet output wire to the positive (+) terminal of the battery.
- Ensure that the two eyelets are properly secured to the battery terminals by ensuring optimal
electrical contact.
- Secure the connector end and cable run with cable ties at a point in the vehicle away from the
fuel line (do not use metal clamps or other material that could damage the output cable).
Charging batteries not connected to a vehicle
1.
Before starting ensure that the power cord is disconnected from the mains socket.
Advertisement
