Table of Contents
Advertisement
Draining
Pull hose
through
guide
Flex hose
guide apart
Fitting the drain hose guide
To prevent siphoning the drain hose should not extend more than 20 mm from the end
of the guide. The height of the standpipe or tub should be between 850 - 1200 mm. The
drain hose can be trimmed to length.
Regularly check that your standpipe or tub is free from lint or other obstructions, which
z
may affect how your washer works or may cause flooding.
In multi-storey apartments or any upper floor, the washer should be installed on a floor
z
equipped with a drain.
Draining must comply with local by-laws.
z
Electrical connection
This appliance must be supplied with a 220 – 240 V, 50 Hz, sinusoidal,
z
10 A electrical supply.
Check the power cord for damage, making sure it is not squashed or twisted.
z
A damaged power cord must be replaced by a Fisher & Paykel trained and supported
z
service technician or qualified person, in order to avoid a hazard. The appliance must not
be operated until it is repaired, as there is a risk of electric shock.
SPARE PARTS*
Hose inlet long (2m)
Hose inlet large bore
Drain hose extension (not suitable for attaching to a spigot)
*Available from your Fisher & Paykel dealer or a Fisher & Paykel trained and supported
service technician.
10
INSTALLATION INSTRUCTIONS
Placing the drain hose in a standpipe or tub:
1 Carefully pull the drain hose out from the
(20 mm)
maximum
2 To guide the drain hose over the tub or
3 Place the drain hose in the tub or standpipe.
back of the washer by pulling the exposed
part of the hose downward and outward.
standpipe the hose guide MUST be fitted to
the drain hose.
Do not fit the hose to a drain spigot.
Drainage must not be airtight in order to
prevent siphoning.
PART NO.
422680P
426123P
425627P
Advertisement
Table of Contents
