Table of Contents
Advertisement
Installation
Note:
Do not place HomePlug devices under direct sunlight or near high-heat-emitting devices;
Do not place HomePlug devices near water or wet surfaces to avoid electric hazards;
Do not place HomePlug devices on any moving or unstable surfaces;
It is recommended that you plug the HomePlug devices directly into the wall outlets, not to any power
adapters, surge protectors or any device that filters signals.
1.Remove the HomePlug to USB adapter, the power cord, the USB cable and the installation CD from
the package.
2.Allocate a space for the adapter's placement. Make sure you avoid the places mentioned
above.
3.Make sure that your HomePlug USB Adapter is NOT plugged in before you install the driver first.
4.If you currently have a 10/100 Base-T network interface card installed in your computer, please
disable the card first.
5.Disable the Microsoft VPN if you have it in your system.
(Note: The following driver installation steps are under Windows XP. Other operating systems will have the similar steps
but the screen may appear different. For Windows 98SE, ME and 2000, you may be prompted to use the Windows CD
under 98SE and ME.)
7
Advertisement
Table of Contents
