Installation of Hard Drive
If you purchased the enclosure model (GHE135C), please follow these instructions to install your 3.5" Hard Disk
Drive. OTHERWISE, PROCEDE TO PAGE 18.
WARNING: Opening ION™ Drive's with built in Hard Drives (GHD135C40, GHD135C60, etc...) WILL VOID
YOUR WARRANTY. For assistance with your hard drive, please contact your IOGEAR service support represen-
tative.
Hardware Installation:
Attention! Please take all proper Electro Static Discharge (ESD) precautions during the installation of your new
hardware. For further information on ESD please visit http://www.esda.org.
Step. 1 Please have the following ready
1 Phillips screw driver (not included in the package)
Step. 2 Remove Base
Remove Phillips screw from bottom
edge of side panel.
Note: For the best performance, please use the certified FireWire or USB 2.0 cable provided with this product.
10