Table of Contents
Advertisement
Calder Brothers Corporation
Model: Precision Spray
If the machine will NOT be operated for a long period of time, prepare
and store it using the procedures as follows.
BEFORE STORAGE
Perform the following prior to placing the machine in storage:
DURING STORAGE
NO
TE
If the Hydraulic Cylinders are operated at this time, BE SURE to wipe the
pro
tective grease (and any adhering dirt) from the Cylinder Rod
starting the Engine. After operating, BE SURE to recoat the Cylinder Rods
with grease
Serial #
944-N-P2C---S-D00000 to Current
1.
Wash off the entire machine.
2.
Lubricate ALL grease fittings as described in Section C -
Fuels and Lubrication, in this manual.
3.
Change Engine oil as outlined in Section H - Service, in
this manual.
4.
Apply grease to all exposed hydraulic Cylinder Rod areas.
5.
Disconnect the Battery Cable Clamps and cover the Battery
or remove the Battery from the machine and store it
separately.
6.
If the ambient temperature (at ANY time during the storage
period) is expected to drop below freezing, make sure the
Engine coolant is either completely drained from the
Radiator and Engine block or that the amount of anti-freeze
in it is adequate to keep the coolant from freezing. Refer to
the separate Engine manual provided for anti-freeze
recommendations and quantities.
7.
Preferably, store the machine inside where it will remain
dry. If it MUST be stored outside, park it on lumber laid
on flat, level ground or on a concrete slab and cover the
machine with a tarp.
1.
About once each month, connect the Battery and check
ALL fluid levels to make sure they are at the proper level
BEFORE starting the Engine.
if
the m
achine is going to be returned
s BEFORE
to storage.
Page68
V2.2
Advertisement
Table of Contents
