Table of Contents
Advertisement
Calder Brothers Corporation
Model: Precision Spray
TRANSPORTING
W
hen loading or unloading in a congested area, be sure flagmen are used to insure the
utmost SAFETY to the operator and other motorists and/or pedestrians in the area.
CAUTION
ALWAYS follow ALL state and local regulations regarding the operation of
equipment on or across public highways! Whenever any appreciable distance
exists between job sites, or if transporting on a public highway is prohibited,
BE SURE to transport the machine using a vehicle of appropriate size and
weight.
L
OADING USING RAMPS
N
OTE
A match
WARNIN
G
ALWAYS abide by the following recommended procedures and guidelines
when using ramps to load the machine onto (or unload it from) a truck or
trailer. Failure to heed these guidelines can result in damage to equipment
and serious personal injury or death!
1.
2.
3.
4.
T
ruck Bed & Top of Ramp MUST
Tire Blocking (Front & Rear)
Serial #
944-N-P2C---S-D00000 to Current
ed pair of ramps is required.
T
he ramps MUST be of sufficient strength to support the machine.
Whenever possible, use strong steel ramps as well as some type of
center supporting block.
The ramps MUST be firm
with NO step between the bed and the ramps.
Incline of ramps MUST be less than 15° (ramp
least 16 feet long.
Ramp width MUST
R
efer to Figure F-1 below.
be Even
Height
Figure F-1
ly attached to the truck or trailer bed
be at least 1-1/2 times the tire width.
Minimu
m Ramp Length MU
Sturdy Center Support
Page41
length MUST be at
ST be 3.9 Times Height
Less Than 15°
V2.2
Advertisement
Table of Contents
