Memory Channels; General; Programming During Selection - Icom IC-R2 Instruction Manual

5

MEMORY CHANNELS

General

The receiver has 400 memory channels in 8 banks for stor-
age of often-used frequencies.
D Memory channel contents
The following information can be programmed into memory
channels:
• Operating frequency (p. 7)
• Receive mode (p. 11)
• Tuning step (p. 7)
• Duplex direction (DUP or – DUP) with an offset frequency
(p. 24)
• Tone squelch ON/OFF (p. 22)
• Tone squelch frequency (p. 22)
• Scan skip setting (p. 18)
[EXAMPLE]: Programming ch 40 of memory bank 5 during selection.
FM DUPTSQL
12
FUNC
+
FM
V/M MW
momentarily
MR

Programming during selection

q Select VFO mode with [V/M].
w Set the desired frequency:
Select the desired band with [BAND].
Set the frequency using [DIAL].
Set other data (e.g. offset frequency, duplex direction,
tone squelch frequency, etc.), if required.
e Push [FUNC] + [
channels.
• Do not hold [FUNC] + [
wise the previously selected memory channel will be overwritten.
r Rotate [DIAL] to select the desired channel.
• VFO (VF), as well as regular memory channels, can be pro-
grammed in this way.
• Rotate [DIAL] while pushing [FUNC] to select a memory bank,
programmed scan edge channel or VFO.
t Push [FUNC] + [
• Keep pushing for 2 sec. or more to automatically select the next
memory channel, if desired.
FUNC
+
for bank for CH
MR
selection selection
blank channel
MW] momentarily to indicate memory
(V/M)
MW] for more than 0.5 sec., other-
(V/M)
MW] for 1 sec. to program.
(V/M)
FUNC
+
FM DUPTSQL
V/M MW
for 2 sec.