I Ut-109 And Ut-110 Installation - Icom IC-F43GT Instruction Manual

I UT-109 and UT-110 installation

The following PC board modification is required when
installing the optional UT-109 or UT-110:
q Rotate [VOL] to turn the power OFF, and remove the bat-
tery pack. (p. 2)
w Remove the unit cover as shown on p. 36 (Optional unit
installation).
e Cut the pattern on the PCB at the TX mic circuit (MIC) and
RX AF circuit (DISC) as shown below.
r Install the scrambler unit as described in the Optional unit
installation (p. 36).
t Replace the unit cover and the battery pack, then rotate
[VOL] to turn the power ON.
OPTIONAL UNIT INSTALLATION
NOTE: When uninstalling the scrambler unit
Be sure to re-solder the disconnected points at left, other-
wise no TX modulation or AF output is available.
7
37