Icom IC-F43GT Instruction Manual page 28

4
BIIS OPERATION
D D Programming an SDM memory
(10-keypad version is required)
q During standby condition, push [P1] (Digital) twice, then
push [UP] or [DOWN] to select the desired SDM to be edit-
ed.
w Push [M] or [#] to enter the message editing condition.
• The first character blinks when [#] is pushed, the last character
M
blinks when [ ] is pushed as below.
e Push the appropriate digit key, [0] to [9], to enter the
desired character.
• See the table at right for the available characters.
• Pushing [UP] also enters space, pushing [DOWN] deletes the
selected character.
r Push [#] to move the cursor to the right, push [M] to move
the cursor to the left.
t Repeat steps e and r to set the desired text message.
y Push [P1] (Digital) for 1 sec. to overwrite the set content
into the memory.
• Push [P1] (Digital) momentarily to cancel the editing and return to
the original message indication.
24
• Available characters
Key Characters
[0] (0) (.) (!)
(_) (() ())
[1] (1) (Space) (#)
(&) (%) ($) (@)
[2] (2) (A) (B)
[3] (3) (D) (E)
(4) (G) (H)
[4]
[5] (5) (J) (K)
[6] (6) (M) (N)
[7] (7) (P) (Q)
[8] (8) (T) (U)
[9] (9) (W) (X)
NOTE: Once the pre-programmed character including a
decimal point is rewrote with the 10-keypad, the decimal
point cannot be displayed again.
(?) (') (") (,) (;)
(<) (>) ([) (])
(✱) (/) (+) (—) (=)
(^)
(C) (a) (b) (c)
(F) (d) (e) (f)
(I) (g) (h) (i)
(L) (j) (k) (l)
(O) (m) (n) (o)
(R) (S) (p) (q) (r) (s)
(V) (t) (u) (v)
(Y) (Z) (w) (x) (y) (z)
(:)
( / )