Memory Clearing - Icom IC-718 Instruction Manual

6
MEMORY OPERATION
D Transferring in memory mode
This is useful for transferring frequency and operating
mode while operating in memory mode.
When you have changed the frequency or operat-
ing mode in the selected memory channel:
• Displayed frequency and mode are transferred.
• Programmed frequency and mode in the mem-
ory channel are not transferred, and they remain
in the memory channel.
q Push [CH], then select the memory channel to be
transferred with [UP Y] or [Z DN] in memory mode.
• And, set the frequency or operating mode if required.
w Push [M
V] for 1 sec. to transfer the frequency and
≈
operating mode.
• Displayed frequency and operating mode are trans-
ferred to the VFO.
e To return to VFO mode, push [V/M] momentarily.

Memory clearing

Any unnecessary memory channels can be cleared.
The cleared memory channels become blank chan-
nels.
q Select memory mode with [V/M].
w Push [CH], then select the memory channel to be
cleared with [UP Y] or [Z DN].
e Push [M-CL] for 1 sec. to clear the contents.
• The programmed frequency and operating mode dis-
appear.
• "BLANK" appears.
r To clear other memory channels, repeat steps w
and e.
38
TRANSFERRING EXAMPLE IN MEMORY MODE
Operating frequency : 14.020 MHz/CW (M-ch 16)
Contents of M-ch 16 : 14.018 MHz/CW
Rotate dial.
6 Push for 1 sec.
M V
Beep
Beep
Beep
1
V/M
VFO A is displayed. VFO A is displayed.
1
V/M
M-ch 16 is displayed.
5 Push for 1 sec.
M-CL
Beep
Beep
Beep