IBM 1U Installation And Maintenance Manual page 55

12. Fasten the keyboard-and-mouse cable to the console unit with the nut and
clamp:
a. Push the keyboard-and-mouse cable into the clamp that you removed in
step 1 on page 41.
Important: Make sure that you place the clamp on the
keyboard-and-mouse cable approximately 70 - 76 mm (2.75 -
3 in.) from where the cable exits the keyboard. This prevents
the cable from hanging below the bottom of the console unit.
Note: In the following illustration, the console unit is turned over and is
placed on a table or other flat surface.
b. Place the clamp on the screw on the console unit frame and hand-tighten
the nut on top of the clamp.
13. Turn over the console unit:
a. Grasp the cable-management arm and the loose cables in one hand.
b. On the opposite end of the console unit, grasp the flat-panel display and
the console unit frame together with the other hand.
c. Carefully turn over the console unit.
14. Route the keyboard-and-mouse cable through the cable-management arm in
the extended position to avoid strain on the cables. Secure the cable with the
hook-and-loop fasteners.
Chapter 4. Hardware maintenance information
45