IBM 1U Installation And Maintenance Manual page 53

4. Carefully lift the flat-panel display to the full upright position.
5. Remove the keyboard and cable from the console unit and set it aside.
6. Unpack the replacement console unit and place it on a table or other flat
surface. Make sure that the right side of the unit extends approximately 76 mm
(3 in.) over the edge of the surface. This will help you route the
keyboard-and-mouse cable more easily. (See the illustration in step 7.)
7. Carefully route the keyboard-and-mouse cable down through the keyboard tray
opening on the replacement console unit, up through the opening on the right
side of the tray, and toward the cable-management arm. Pull the full length of
the cable through the opening.
8. Place the keyboard in the tray and press the hook-and-loop fasteners together.
9. Close the flat-panel display.
Thumbscrews
Chapter 4. Hardware maintenance information
43