Fisher & Paykel HBD600I Installation Manual/User Manual page 22

Prepare for electrical connection
6
Downdraft unit
Remove the cover of the terminal box from the downdraft unit Fig.14.
●
Decide whether the power source should enter the downdraft unit from below or
●
from the back and remove the respective knock out. Install a UL listed strain relief or
conduit fitting (not included) in the knock out Fig.15.
If the downdraft unit is being installed with a remote blower, remove the knock out
●
for the control cable.
With the assistance of another person, lift the downdraft unit into the prepared cutout
●
in the cabinet. The over counter mounting brackets should rest on the countertop.
Secure the downdraft unit to the floor and countertop with screws into the previously
●
drilled holes Fig.16.
Fig.14
Push the end caps into place on the downdraft unit on top of the counter and lock
●
them in place Fig.17.
20
INSTALLATION INSTRUCTIONS
Fig.15
Fig.17
Fig.16
6 x
2 x