Install Cabinetry Attachment Brackets - Fisher & Paykel RB2470BRV1 Installation Manual

Install cabinetry attachment bracket to the appliance
Remove the pre-existing screw/plastic
1
washer (A) and plastic plugs (B) on
the non-hinge side bottom corner of
the appliance.
Attach the position adjustment plate (C)
2
to the cabinetry attachment bracket (D)
by inserting the knobs of the plate into
the holes of the bracket.
3 Install the cabinetry attachment bracket
to the bottom non-hinge side of the
appliance by inserting two screws (E)
into the existing plug holes.
– Do not tighten fully to allow for
adjustment.
!3

INSTALL CABINETRY ATTACHMENT BRACKETS

B
A
D
C
Loosely screw in, to enable
bracket to slide side to side
E
Adjust the air flow stops
Adjust the air flow stops located on the back cover of the compressor. Ensure the air flow
4
stops make contact with the cabinetry.
IMPORTANT!
It is possible for the air flow stops to get flattened during transport. If this happens,
unfurl the air flow stops to ensure they meet the back of the cabinetry to help airflow.
Air
outlet
Air flow
stops
Adjust the air flow stops
Air inlet
13