Using the cooktop burners
1 Identify the knob of the burner
you want to use.
3 When the burner has lit, turn the
knob to any setting between HI (high)
and SIM (simmer).
The clicking should stop as soon as
●
the burner has lit.
If the burner doesn't light, and/or the
●
clicking doesn't stop, or the flames
are not blue and well-defined, turn
the knob clockwise back to OFF and
see 'Troubleshooting' for advice.
30
COOKTOP USE
Halo
(Orange)
2 Push the knob in and turn it
counterclockwise to LITE.
Make sure you stop at LITE before
●
turning the knob to any flame setting.
The halo will glow orange.
●
You will start hearing a clicking sound.
●
If there is no clicking, turn the knob
clockwise back to OFF and see
'Troubleshooting' for advice.
4 When you have finished cooking,
turn the knob clockwise back to OFF.
The knob will release and the burner
●
and halo will go out.
If you are using LP gas, there may be
●
a slight 'extinction pop' or flash at
the flame spreader a few seconds
after the burner has been turned off.
This is normal for LP gas.
Halo
(Orange)
Halo
(Unlit)