Table of Contents
Advertisement
1. Check level of floor where cases are to be set.
Determine the highest point of the floor; cases will
be set off this point.
2. Set first case, and adjust legs over the highest part of
the floor so that case is level. Prevent damage - case
must be raised under leg or by use of x6 or x4 leg
brace. Remove side and back leg braces after case
is set.
Bumper installation instructions
Step 1: Make sure the aluminum channel and end caps
are installed.
Step 3: Starting on one end: while inserting the bumper,
push it up against the end cap to prevent
the bumper from shrinking after installation
(when it gets cold).
installation (Cont'd)
It is the contractor's responsibility to install
case(s) according to local construction and
Step : Use silicone lubricant to help the
bumper slide into the channel.
Step 4: As you insert the bumper into the channel with
one hand, pull the bumper toward you with
the other to open the inside lips. Slowly
apply pressure by rolling the bumper into
the track.
4
iGiC-ism-0608
health codes.
Advertisement
Table of Contents
