Table of Contents
Advertisement
Waxing
If after removing dirt and grease, the acrylic can be waxed
with a good grade commercial wax. This will improve
the appearance of the surface by filling in most minor
scratches. Wax should be applied in a thin even coat and
brought to a high polish by rubbing lightly with a dry clean
soft cloth, such as a cotton flannel. Excessive rubbing may
cause scratching and/or buildup an electrostatic charge
which attracts dust and dirt to the surface. Blotting with a
clean damp cloth is recommended to remove charge.
BEFORE SERVICING
Disconnect both Attachment Plugs to
completely De-energize unit. Failure to
disconnect both plugsmay result in damage
to equipment, serious personal injury!
This includes (but not limited to) Fans,
Heaters,Thermostats and Lights.
evaporator Fans
The evaporator fans are located in front of the CAD,
directly beneath the display pans. Should fans or blades
need servicing, always replace fan blades with the raised
embossed side of the blade TOWARD THE MOTOR.
Copper Coils
The copper coils used in Hussmann merchandisers may
be repaired in the field. Materials are available from local
refrigeration wholesalers.
Hussmann recommends using #15 Sil-Fos for repairs.
ism
With Power Cord/R404A
With Power Cord
User information (Cont'd)
antistatic Coatings
For acrylic used indoors, antistatic coatings successfully
prevent the accumulation of an electrostatic charge for
periods of several months - if the surface is not washed
or wiped down with a wet cloth. Between applications of
the antistatic coatings, the parts need only be dusted with
a soft clean cloth to maintain a good appearance. In use,
liquid antistatic coatings should be applied in a very thin
even coat. If beads appear as it is applied, the coat is too
thick and the excess should be removed with another
cloth. Allow the coating to dry, then bring to a high gloss
with a soft cloth.
maintenance
Tips and Troubleshooting
Before calling for service, check the following:
1. Check electrical power supply to the equipment for
connection.
2. Check fixture loading. Overstocking case will affect
its proper operation.
3. If frost is collecting on fixture and/or product, check
that no outside doors or windows are open-allowing
moisture to enter store.
SERIAL NUMBER Handy. This Information
access Panels
All ELECTRICAL and drain access panels are clearly
labeled on the deck of the deli/cheese stand. The access
for condensing units (in the self contained units) is located
on the side of the stand, at the end. Ends of stand are fitted
for removal, if condensing unit has to be taken out.
electrical Wiring diagrams
1
FOR PROMPT SERVICE
When Contacting the Factory for support,
Be sure to have the CASE MODEL and
is on a plate located on the case itself.
4'
4'
iGiC-ism-0608
1H0710
W5000388
Advertisement
Table of Contents
